Jun 06, 2023

Public workspaceConfocal imaging and digital image analysis

DOI
dx.doi.org/10.17504/protocols.io.3byl4jmxzlo5/v1
  • Hong-Yuan Chu1,2
  • 1Van Andel Institute;
  • 2ASAP
Johnson Agniswamy
Icon indicating open access to content
QR code linking to this content
DOI: dx.doi.org/10.17504/protocols.io.3byl4jmxzlo5/v1
Protocol Citation: Hong-Yuan Chu 2023. Confocal imaging and digital image analysis. protocols.io https://dx.doi.org/10.17504/protocols.io.3byl4jmxzlo5/v1
License: This is an open access protocol distributed under the terms of the Creative Commons Attribution License,  which permits unrestricted use, distribution, and reproduction in any medium, provided the original author and source are credited
Protocol status: Working
We use this protocol and it's working
Created: May 31, 2023
Last Modified: May 31, 2024
Protocol Integer ID: 82665
Keywords: confocal imaging, digital image analysis, Spine density analysis, ASAPCRN
Funders Acknowledgements:
ASAP
Grant ID: ASAP-020572
Abstract
This protocol describes confocal imaging on a Nikon A1R confocal microscope and digital image analysis.
Attachments
Icon for 727-1838.docx
727-1838.docx
15KB
Materials
Apparatus

  • Nikon A1R confocal microscope


Confocal imaging on a Nikon A1R confocal microscope
Confocal imaging on a Nikon A1R confocal microscope
Turn on the power of laser, microscope, and computer.
Open the NIS-Elements AR software.
Set lightpath to Eyepiece to locate brain slice under 10x lens.
Once the brain slice is located, switch the lighpath to camera.
Check the pinhole size and make sure it is set to 1.2.
Check for lasers of interest and make sure they are in use.
For scanning, set resolution to 256x256 so that you can find the target regions as fast as possible.
Adjust Z using knob to find slices.
For the imaging of vGluT2, the immunostaining signals were taken between 5 and 8 µm below the surface of slice using a 100x objective lens with a 0.15 µm interval.
For the imaging of neuron density, NeuN-ir signals are collected using a 40x objective lens (1024 X1024 pixels; z step = 1 μm).
Digital image analysis: Spine density analysis using Imaris
Digital image analysis: Spine density analysis using Imaris
Convert the confocal images (.ND2) to imaris images (.ims) using the convert function of imairs.
Open the images in imaris.
Add a new filament and skip the automatic creation.
Select “AutoPath” algorithm method and put your pointer in the “Select” mode.
Press shift and right click at the beginning of the dendrite of interests.
Let the algorithm starts quantified in a starting point.
Move the cursor from the beginning to the end of the dendrite.
When reach the end of the dendrite, press shift and left click to specify the end of the dendrite, make sure the length of the dendrite is around 20-30 microns.
Re-construct and quantify the spines manually.
The spine density = amount of spines/length of dendrite.